MARKING-SYSTEMS 19 PAUL-ROELTGEN-STRASSE 10 · D-42699 SOLINGEN · TELEPHONE: +49 212 / 33 99-0 · FAX: +49 212 / 33 99 11 · WWW.ROELTGEN.DE · INFO@ROELTGEN.DE PNEUMOHYDRAULIC STAMPING PRESSES Group 1720 Pneumohydraulic stamping presses, Pressing force 4 – 50 tonnes Completely connection ready. Only requires a 6 bar compressed air connection. The two-hand controls which have been approved by the trade association mean that the presses meet the latest workplace health and safety regulations. The complete mechanism is hidden behind the covering rack. The pneumohydraulic cylinders in this stamping press exploit the advantages of air and oil. The use of air, a fast medium, means that the distance between the zero point and the workpiece can be covered quickly. Given that air at high loads is not very protective of either marking tool or workpiece, once a force of a few Newtons is reached, the system switches over to oil and marks the label onto the workpiece powerfully but gently. The unusual design of this modern press was not developed solely to be aesthetically pleasing - it has other advantages, too. The shape allows for a larger immersion depth which means that it can be used to mark larger workpieces. 1 power cylinder (40 kN to 500 kN) 2 compressed air connection (Festo KSS 6 connector) 3 manual on/off valve (lockable) 4 filter regulator valve with water trap and manometer (pneumatic) 5 tool holder (standard holder for stamping tools: 40 kN: Ø 15H9 mm x 30 mm, 80 kN and 140 kN: Ø 20H9 mm x 40 mm, 300 kN and 500 kN: Ø 30H9 mm x 40 mm) 6 t-groove table to hold tool 7 two hand safety control buttons 8 emergency off button with key unlock 9 "control on / off" switch 10 hydraulic manometer 11 counter 12 hydraulic switch 13 housing (removable) Subject to change. 05-14
RkJQdWJsaXNoZXIy NTkxOTE=